DDI: +64 (0)7 213 1395
info@techlight.co.nz
Installed inside the luminaire or lamp pole (internal configuration), enabling the transmission of information, and the reception of control commands for the luminaire. Includes built-in energy meter and possesses auto-commissioning functionality.
Controls LED/HID luminaire to provide On/Off and dimming functionality using DALI or 0-10V and built in On/Off switch
Luminaire power consumption measurement to 1% accuracy
Analogue and digital input for interfacing with external sensors
Internal or external enclosures
Two types of Internal or external configurations enclosures- NEMA: ANSI C136.41, 7pin; or conduit wiring
Dual backup protection autonomous operation based on a pre-programmed scenario; built in light sensor (in external configuration), no dayburn
Supports over the air firmware upgrade
Data and settings preserved in case of power failure
Data acquired and stored in unit even during communication loss
LCU stores history of measured parameters for at least a week to allow for data extraction
MTBF of over one million hours
GPS receiver or NFC chip for autonomous registration and commissioning
Controlled Auxiliary Output (optional)